Heart Shaped, Valentine's Day Card, Stampin' Up!

Hello and welcome to my blog. Today I did get the Valentine's Day card made for my mom. I found one on Pinterest that I liked, you can see it by clicking here. I changed it a bit and used items that I have on hand. Please read on to see how it was made.

The base of the card is a folded half-sheet of Petunia Pop card stock. It opens on the right and the fold is on the left.

I cut a 2-1/2" x 5-1/4" piece of Designer Series Paper (DSP) from the "Timeless Plaid" 6" x 6" stack.  I taped it to the left side of the card leaving a 1/4" border on the top, bottom and side.

A 3" x 4-1/4" piece of Blackberry Bliss card stock was cut for the layer. On top of that is a 2-3/4" x 4" piece of Basic White for the focal point.

I stamped the heart from the "Heart Shaped" bundle using Soft Sea Foam ink. Using the matching heart die I cut the heart from the same colored piece of DSP in the "Timeless Plaid" stack. I added little dots of glue to the leaves and set it in place over the Soft Sea Foam stamped image.

Three flowers were cut, two from Petunia Pop and one from Blackberry Bliss card stock. I glued them in place on the side of the heart. I wasn't sure what I was going to put in the centers. I needed something low because I didn't want to pay extra postage to mail it. I ended up using some retired sequins I had. I also glued a couple of them to the outside of the heart.

The words were done on my computer because I didn't have any sets with those words. I cut them out using the die from the same "Heart Shaped "bundle. I snipped off the ends because it was a bit too long, which is too bad because it's such a pretty die. Dimensionals were added to the back and it was set in place under the heart.

Dimensionals were added to the whole piece and it was centered on the front of the card and the card was done. 

The card has a soft subtle look and I'm sure my mom will love it.

Thank you SO very much for taking your time to stop in and see today's Valentine's Day card,
Wanda