The base of my card is a folded half-sheet of Basic White card stock. It opens on the right and the fold is on the left.
I cut a 4" x 5-1/4" piece of Basic White card stock and textured it using the "Snowflake Sky" embossing folder. I glued that to the front of the card.
Next I cut the frame. I used the 3rd and 5th smallest rectangle dies in the "Deckled Rectangles" set. I lined them up, used some removable tape and then ran them through my Big Shot. Dimensionals were added to the back and the piece was set aside.
I cut a 2-3/8" x 3-5/8" piece of Designer Series Paper (DSP) from the "Sentimental Christmas" 12" x 12" package. I removed the protective pieces from the Dimensionals and set the rectangle on top of the piece of DSP. I added glue to the back and centered it on the front of the card.
The snowman is from the "Joyful Images Ephemera" package. You get two of them in the package. I had used one on a previous card and I was saving the other one. For what I don't know. Perhaps so the package can retire and I'm sitting here with more things I didn't use. SO taking a hard look at my past behaviors in not using things I decided to go ahead and use it. I added a small Dimensional on the right side of the middle and lower snowballs. I added glue along the backside where it would be touching the frame. I set the snowman in place. I took a branch piece from the package and set it in place with a Dimensional.
The strip the words are on is also from the same package. The words are from the "Sophisticated Sled" bundle. I stamped them on a scrap piece of Basic White card stock using black Memento ink. I laid the word piece on top of the strip and I trimmed it so it was the same width as the strip. My strip was 5/8" before trimming. That strip is a little over a half-inch so there wasn't a lot to trim off. I snipped the ends of the word piece. I slipped the strip under the snowman to see where it needed to be glued down. Once it was glued I added the strip to the front of the card. I used a couple of small Dimensionals on the inner part and I glued the end part down.
And for the final touch I glued on a bunch of snowflakes from the "White Loose Snowflakes" container. And the card was done. I like how it turned out and I have no regrets using the last snowman in that package.
This was a fun card to make. I like the layout and I like how quickly it went together.
Thank you SO very much for taking your time to stop in and see today's Christmas card,
Wanda
1 comment:
That cute little snowman just makes me smile! Love it!
Post a Comment