The base of the card is a folded half-sheet of Basic White card stock. I cut a 4-1/8" x 5-3/8"piece of Bubble Bath card stock. I taped it to the card base.
Next I die cut the lattice piece using the die from the "Split Card Texture Dies" set. I used tape on the upper part and glue on the bottom. I did a hit and miss with the glue because it would be too difficult to glue every one of those lines. Double-sided sticky sheets would work well for this.
The word piece is from the "Wanted to Say" die set. I used Basic Black card stock for the words and Berry Burst for the background. I glued the words in place and then set the piece on the front of the card using Dimensionals.
The flower is from the "Darling Details" set and was stamped using Berry Burst ink for the outline and Bubble Bath ink for the solid part. I die cut the piece. Then I colored the solid part in with my Wink of Stella pen. The leaves are from the same set and were stamped using Granny Apple Green ink for the outline and the same in stamped off once for the solid part. The flower was set in place using Dimensionals and the leaves were added using a little bit of glue. And that was it.
It was a very simple and quick card to make. I really like that lattice looking piece. I need to use that die more.
2 comments:
GREAT card layout Wanda.
I absolutely love that die! I had debated about whether I "needed" it but so glad I bought it. So far I haven't used it horizontally but I do love using it vertically.
Post a Comment