Go To Greetings, Dainty Flowers, Thank You Card, Stampin' Up!

Hello. I'm  glad you found your way here today. I have a fun card to share with you using scraps. Please read on to see how I made this card.

The base of my card is a folded half-sheet of Mossy Meadow card stock. The card opens on the right and the fold is on the left. The first thing I did was cut a 4" x 5-1/4"piece of Basic White for the inside of the card. I taped it in place.

Next I had a piece of Designer Series Paper (DSP) from the "Dainty Flowers" 12" x 12" package. I had cut the piece for a prior card. The piece measured 4" across the top. The right side came down 4-3/4" and on the left it came down 3-3/4".  

The smaller piece on the bottom is a piece that was cut 1-1/2" x 4". I taped that piece down first and then the larger piece was added.

The center panel image is from the same DSP package and it was cut at 2-1/2" x 5-1/4". And the Mossy Meadow layer was cut at 2-5/8" x 5-1/2".  Before you tape the DSP to the Mossy Meadow layer you can punch out the scalloped oval using the "Dual Oval" punch. I had a scrap piece so I used that. 

The words are from the "Go To Greetings" set and were stamped using Mossy Meadow ink. Then they were punched using the oval in the "Dual Oval" punch. I taped the ovals together and added Dimensionals to the back. I set the piece in place on the upper right area of the card and the card was done.

This was a quick card to make and it was nice to use an odd shaped piece of DSP. 

Thank you SO very much for taking your time to stop in and see today's thank you card,

Wanda