The base of my card is a folded half-sheet of Basic White card stock. I cut a 4-1/8" x 5-3/8" piece of Basic Black card stock for the layer. I taped it to the front of the card.
I took a 4" x 5-1/4" piece of Basic White card stock and textured it using the "Ornate Floral" embossing folder. I glued that to the Basic Black piece.
The Designer Series Paper (DSP) is from the "Daffodil Afternoon" 12" x 12" package. A 2" x 3-7/8" piece of the DSP was cut for the focal piece.
A 3" x 4" piece of Basic Black card stock was cut and the bottom was die cut using the die from the "Color & Contour" bundle. I lined up the bottom of the bumps to the bottom of the card stock so not a whole lot of card stock was cut off. The piece measured about 2-7/8" when I was done. It's okay if yours is a little smaller, it's not going to distort the card at all. You will just adjust the ribbon and make things look even.
I took some black ribbon that I had and cut a piece 5" long and taped the ends on the backside. I slipped the ribbon (still on the spool) under the taped ribbon, tied a knot and then snipped the ribbon. I like this kind of knot because I can slid it where I want it. I glued this piece to the front of the card.
The words are from the "Eden's Garden" set and were stamped using black Memento ink on a scrap piece of Basic White card stock. I punched them out using the "Double Oval" punch. I also punched out the scalloped Basic Black oval using the same punch. I taped the two ovals together and added Dimensionals to the back. I set the words in place and the card was done.
This is a very quick and easy card to make and it's a very rich looking friendship or sympathy card.
Thank you SO very much for taking your time to stop by and see today's friendship card,
Wanda
GORGEOUS card Wanda. I'm in LOVE with every single thing on this card. TFS!
ReplyDelete