Penguin Place, Penguin Playmates, Stocking Stuffer, Weekend Project, 2021 Stampin' Up! Holiday Catalog

As I was trying to find a card to make today, I ran across this cute little gifty item to make. I found it here on Pinterest. There is also a video you can follow along to. I thought it would be great to make several of these to pass out to the mail carrier, USP driver, the ones who load my groceries in my trunk each week and more. I have a long list.  Just a little fun something. These are SO quick and easy to make. Plus they are a great way to use up some of that extra Designer Series Paper (DSP) you have. 

The DSP is from the "Penguin Playmates" 12" x 12" package and was cut at 3-3/4" x 6".  I added a strip of strong tape to one of the long sides. You just set the candy bar on top. This candy bar is not  a full-sized bar, it's a .071 oz. bar. Or the 100 calorie bar, whichever way you can find it in the store. If you're using the smaller ones, just adjust your DSP to fit. You will still need it to be 3-3/4" on the one side. You will need 1-3/4" more for the slack inside the tube. So measure your candy bar and add 1-3/4".  

Set the DSP face down and place the candy bar on top. Wrap the piece without the tape over it first and then affix the other edge on top. 

The bottom was just stapled. You can glue it or enclose that end any way you'd like. The instructions showed stapling it so I just followed a long.

I did have the "Label Me Fancy" punch that was used to make the hole in the top. Though you could use a anything to make a hole. I saw how she struggled to get the ribbon through the hole so I punched a little to the left of my first hole and then a little to the right so it was more elongated and wide enough for the ribbon. I added the ribbon and was ready to move onto the tag.

The white scalloped rectangle tag part is from the "Color & Contour" bundle. I cut it from a scrap piece of Basic White card stock.

I punched out the penguin body from a scrap piece of Basic Black card stock and the white part from a scrap piece of Basic White card stock.

The eyes were stamped using black Memento ink and the beak and feet were stamped using Pumpkin Pie ink. I glued it higher up on the rectangle

I stamped the words from the "Penguin Place" and trimmed them so only the "Be Merry" was left. They were just fussy cut and taped in place just under the Penguin.  I glued the piece to the front of the tube and it was done. I chose glue because I wanted to make sure it was going to stay put since it hangs over on the edges and could get caught on something and rip off. 

If you like to give it a more personal touch, you could always print out the names of the people you are giving these to and tape it on the tag.   

This was such a cute idea, wasn't it? I am glad I ran across it. It's very quick and easy to make too! Can't ask for more than that, especially this time of the year.

Thank you SO very much for taking your time to see today's fun Christmas project,
Wanda