The base of the card is a folded half-sheet of Basic Black card stock. This card opens on the bottom and the fold is on the top.
I cut two piece of Basic White at 4" x 5-1/4". One for the inside and one to texture for the top of the card. It was textured using the "Tasteful Textile" embossing folder and glued in place on the top of the card.
I cut the Designer Series Paper (DSP) from the "Cute Halloween" 6" x 6" stack at 4-1/2" x 2-1/2". The Basic Black layer was cut at 4-3/4" x 2-3/4" and the DSP was taped to it. I added Dimensionals to the back and set it aside.
Then the dotted paper was cut at 3-7/8" x 2-1/4". It's from the same DSP stack. I marked the bottom center and then marked 1/2" up from there. I snipped from the corner to the mark that is 1/2" up. I repeated that for the other side to form the ribbon looking end. I glued this piece in place on top of the embossed Basic White card stock, about 1/8" from the right edge of the Basic White card stock.
Next the layered bat piece was set in place over the ribbon piece. I lined up the left, top and right so they looked pretty even.
The words are from the "Frightfully Cute" set and were stamped on a scrap piece of Basic White card stock using black Memento ink. They were die cut using the cute die from the "Frightful Tags" dies. I love this shape, it's so fun and the piercing around it is a perfect touch. I added Dimensionals to the bottom part and snail tape to the upper part and I set it in place on the front of the card.
The other piece of Basic White card stock was added to the inside and the card was done.
This was such a cute, kid-friendly card and a perfect last card for the Halloween season!
Thank you SO very much for taking your time to stop by to see the final Halloween card of the year,
Wanda
1 comment:
What a great layout Wanda.......And a wonderful way to end the 2021 Halloween season.
Post a Comment