Cute Halloween, Frightfully Cute, Kid Friendly Halloween Card, Polaroid Technique

I had so much fun making the Polaroid technique card yesterday that I had to try it again. But I did not go to the dark side this time. I wanted to add some color. I stepped out of my box yesterday but went back in it today. I just like color!!

The base of my card is a folded half-sheet of Basic White card stock. This card opens on the right and the fold is on the left.  

I cut a 4-1/8" x 5-3/8" piece of Basic Black card stock and I glued it to the card base.

I used the colored dotted sheet from the "Cute Halloween" 6" x 6" Designer Series Paper (DSP) stack. I cut the piece 4" x 5-1/4" and glued it to the Basic Black piece.

For the Polaroid piece, I cut the Basic White card stock at 3" x 3-3/4".  Then I took a 2-3/8 square die and cut the piece, setting the die at the upper part and making sure it was even on both sides and the top.  I used a piece of Post It tape to hold my die in place so it wouldn't shift as I cut it.  

I also cut a 3-1/8" x 3-7/8" piece of Basic Black and glued the White Polaroid piece to it.

The ghost DSP is from the same "Cute Halloween" DSP stack. I cut it at 2-1/4" x 2-1/4" and I glued it to the inside of the Polaroid piece. 

The words "frightfully cute" are from the "Frightfully Cute" stamp set and were stamped using black Memento ink right on the bottom of the Polaroid piece. 

Dimensionals were added to the Polaroid piece and it was set in place on the front of the card. I liked it sitting at an angle because it gives it more character. And that was it.

Thank you SO very much for taking your time to stop by and see today's Polaroid technique card,
Wanda