I saw this layout on a card on Pinterest and I thought I would use it on a Halloween card. I have LOTS of the "Monster Bash" Designer Series Paper (DSP) left and I thought I would and should use some of it. I think I have lots of paper from previous years too! I never seem to use them up. Any suggestions for storing them? I don't use them for scrapbooking so I don't need or want them to be 12" x 12".
The base of my card is a folded half-sheet of Very Vanilla card stock.
I took a 5-1/2" x 3" piece of the DSP from the "Monster Bash" pack. I measured 1" in on the top left and 1" in on the bottom right and made light pencil dots on it. I taped it to a 5-1/2" x 3" piece of Very Vanilla card stock and then I cut the paper at a diagonal, matching those pencil lines on the paper cutter.
On the backside of the monster DSP was the spider web image, so I cut a piece of that at 5-1/2" x 2-1/2". I taped it to the card front, being sure to center it.
I added Dimensionals to the back of the diagonal cut pieces and I set them in place on top of the webbed DSP.
I die cut the spider and the word "Wicked" from the "Wicked" dies. I set both of them in place on the front of the card using Dimensionals. Be sure to set the words on the card first to see where NOT to add the Dimensionals. They are not all that easy to remove once the words are set in place. Speaking from experience here.
I think it's a pretty cute card. I LOVE those characters on the DSP.
Thank you SO much for stopping by today,
Wanda
No comments:
Post a Comment