Signs of Santa, Santa's Workshop SDSP, Christmas Card, 2018 Stampin' Up! Holiday Catalog

I needed to make a quick card because I had to post to my blog and it was getting late. I am fighting a horrible cold and it's draining my energy.  I figured I could make a quick card and get it posted in time if I used the "Signs of Santa" set.  SO here's my quick card.

The base of my card is a folded half-sheet of Whisper White card stock. On top of that is the green dotted paper from the "Santa's Workshop" Specialty Designer Series Paper (SDSP).  This particular piece of the SDSP does not have any fuzzy features to it on either side so I didn't feel sad about using one side over the other!

I stamped Santa using black Memento ink. I cut the Whisper White card stock for the image at 3-1/8" x 3-1/8".  And I cut the Poppy Parade layer 3-1/4" x 3-1/4".  I taped those two layers together and placed Dimensionals on the back.  The words are from the same set and I stamped them using Garden Green ink.

I took some of the new white "Metallic Edge" ribbon.  I taped the edges of the ribbon to the back and I tied a bow on the right side. I like those kinds of bows because you can slide them along the ribbon strip and place them where you wish. After adding the ribbon I taped the SDSP in place on top of the card base.

I removed the protective backing from the Dimensionals and set Santa in place.

The inside reads, "... and more!" and I stamped them using Garden Green ink.  And that was it.  A quick and simple card.  And now I'm off to go lay down again.  

Thank you SO much for visiting today,
Wanda