I found a fun card on Pinterest and I wanted to copy it. Apparently it was an older post, it used the white clay that was sold a few years back, along with the rose mold. It also had a fern image that is no longer available. SO I updated and remade the card using what was current. Making do with what I have! Sometimes you just HAVE to!!
I took a photo of the layer before I taped every thing onto it so you could see where I placed things. I started out with some Crumb Cake ink and I stamped the square grid image twice in the bottom left corner. Then I took the dotted image and stamped part of it twice on the center right side.
I took a photo of the layer before I taped every thing onto it so you could see where I placed things. I started out with some Crumb Cake ink and I stamped the square grid image twice in the bottom left corner. Then I took the dotted image and stamped part of it twice on the center right side.
Next I took the Pear Pizzazz ink and the lacy leafy looking image from the "Timeless Texture" set and stamped 3 leaves.
I took the coffee ring image and stamped it several times on top, I did stamp off before stamping directly onto the card stock. I also stamped a couple of rings on the bottom right. I stamped one on the center left and I did not stamp off, I wanted this to show through the paper doily. And lastly I used the dotted image to stamp some splats around the outer edges of the card, I did not stamp off on those.
I die cut my butterfly using Powder Pink card stock. The layer behind the Whisper White piece is Powder Pink as well.
The base of this card is Crumb Cake, it's a folded half-sheet.
I added the half doily. Then I taped the Powder Pink layer to the Crumb Cake base. On top of that I taped the Whisper White piece. The words piece was cut 3" x 1-1/4" and the Powder Pink layer was cut 1-3/8" x 3-1/8". The words were stamped using Soft Suede ink. I wanted something darker than Crumb Cake. I taped those layers together and I added Dimensionals on the back and set it in place.
I set the butterfly in place with two pieces of Dimensionals on the upper part of the body. I added a little snail tape to the end of the body that would be touching the word layer. I added 5 pearls down the center. Then I thought it could use something else so I added Wink of Stella to the entire butterfly. I recommend you do this before you attach it. And that was it.
I did have trouble deciding if this was going to be a birthday or wedding card. I may make another one as a wedding card. It was a fun card to make and I do like how it turned out.
Thank you SO much for visiting today,
Wanda
Thank you SO much for visiting today,
Wanda
2 comments:
this card is very cool.
GORGEOUS! You're right, it would make a beautiful wedding card.
Post a Comment