I found a fun card on Pinterest and I wanted to copy it. Apparently it was an older post, it used the white clay that was sold a few years back, along with the rose mold. It also had a fern image that is no longer available. SO I updated and remade the card using what was current. Making do with what I have! Sometimes you just HAVE to!!
I took a photo of the layer before I taped every thing onto it so you could see where I placed things. I started out with some Crumb Cake ink and I stamped the square grid image twice in the bottom left corner. Then I took the dotted image and stamped part of it twice on the center right side.
I took a photo of the layer before I taped every thing onto it so you could see where I placed things. I started out with some Crumb Cake ink and I stamped the square grid image twice in the bottom left corner. Then I took the dotted image and stamped part of it twice on the center right side.
Next I took the Pear Pizzazz ink and the lacy leafy looking image from the "Timeless Texture" set and stamped 3 leaves.
I took the coffee ring image and stamped it several times on top, I did stamp off before stamping directly onto the card stock. I also stamped a couple of rings on the bottom right. I stamped one on the center left and I did not stamp off, I wanted this to show through the paper doily. And lastly I used the dotted image to stamp some splats around the outer edges of the card, I did not stamp off on those.
I die cut my butterfly using Powder Pink card stock. The layer behind the Whisper White piece is Powder Pink as well.
The base of this card is Crumb Cake, it's a folded half-sheet.
I added the half doily. Then I taped the Powder Pink layer to the Crumb Cake base. On top of that I taped the Whisper White piece. The words piece was cut 3" x 1-1/4" and the Powder Pink layer was cut 1-3/8" x 3-1/8". The words were stamped using Soft Suede ink. I wanted something darker than Crumb Cake. I taped those layers together and I added Dimensionals on the back and set it in place.
I set the butterfly in place with two pieces of Dimensionals on the upper part of the body. I added a little snail tape to the end of the body that would be touching the word layer. I added 5 pearls down the center. Then I thought it could use something else so I added Wink of Stella to the entire butterfly. I recommend you do this before you attach it. And that was it.
I did have trouble deciding if this was going to be a birthday or wedding card. I may make another one as a wedding card. It was a fun card to make and I do like how it turned out.
Thank you SO much for visiting today,
Wanda
Thank you SO much for visiting today,
Wanda
this card is very cool.
ReplyDeleteGORGEOUS! You're right, it would make a beautiful wedding card.
ReplyDelete