Petite Flowers Mother's Day Card

I found this fun Petite Petals card made by Mel on Split Coast Stampers.  I did change it a little.  I added the Dotted embossed background and the words along with the Modern Label punch are different.  

I used Cherry Cobbler ink and card stock.  I used a 1" punch to do the squares where the flowers are.  To get those squares where they needed to be I had first punched out the center one.  Then I took the square piece and traced it next to the center square to make sure it was where I wanted it to be.  Then I did the same with the other side so they were even.  Next I put the piece with the three punched squares on top of the Cherry Cobbler piece.  I taped the punched out squares into place and then removed the front piece.  I had not embossed it yet.  You want to wait to do that because you don't want that background where the flowers go to be dotted.  

I stamped and punched the flowers and set them in place using Dimensionals.  The Dotted piece is also set in place using Dimensionals.  I punched out the label piece using the card stock that is behind the dotted piece.  I didn't want to get out a new piece of Cherry Cobbler just for the label.  And no one can see it, it's behind the Dotted white piece.  

The words are from the Teeny Tiny Wishes set and they were set in place using Dimensionals too.  Lot of Dimensionals are used on this card!!  Oh, I almost forgot about the flowers.  They are stamped using Cherry Cobbler ink and punched out.  After they were set in place using Dimensionals, I added a pearl to the center of each one.  

A very simple card to make.  And I LOVE red and white cards!!!

Thank you SO much for visiting today,
Wanda